Connect the bracket holding the spring in place to the header support block. Attach the rail of the driver to the bracket and also install the motor. To mount the trim, utilize a paint scraper to obtain rid of the old caulk. The plastic trim is mounted with finish nails. Paint the door.
Bring the cable television up from below, as well as affix it to the pulley wheel on both sides. Turn the wheel so the slack is drawn tight over the pulley from the door side. Transform the wheel so the slack is pulled tight over the pulley-block from the door side. Move the wheel to the header brace, as well as tighten it firmly.
Rest the bent section of the track on the vertical item you mounted previously, and also affix the other end to the ceiling brace. Utilize the same ceiling sustains that were utilized with the old door. Connect the straight track to the upright track on the door. Do not tighten the screws firmly till you're sure the door fits properly as well as align smoothly.
Set up the 2nd panel in addition to the first one, hammering nails into the side jambs to hold it area. Mount the hinges and also repeat the procedure for nonetheless several panels are essential. You will certainly need to secure each piece right into the door jamb.
Attach joints to the top of each panel. Several new doors included pilot holes drilled by the supplier. Affix axle supports to the bottom of the bottom panel and to the top of the top panel. Place the bottom panel right into the door opening. Hold the panel upright by driving a nail right into the wall next to the panel as well as bending it over to hold the panel in position. Make certain it's level prior to affixing the next panel.
Remove the nuts on top of the next panel down. The very first panel ought to come right out. Continue this treatment till all the panels have actually been gotten rid of. Get rid of the old door tracks and the laser sensing unit that maintains the door from shutting when a things is beneath it. Get rid of the braces holding the track in place. Detach the track from the brackets that allow it to hang from the ceiling. Keep a company grip on the rail or it will certainly drop.