Glide the torsion rod right into the holes in the side header brackets. Make sure the pole is safe, after that affix the pulley-blocks per end of the rod. Secure the facility header bracket to the facility mark on the header. You'll possibly have to raise the facility of the assembly to get it degree prior to attaching it.
Connect the following panel in addition to the first one. Make certain the groove of the top panel hinges on the ridge of the reduced panel. Repeat the process until all the panels remain in location. The final panel must extend 1' or so past the top of the door opening.
Attach the bracket holding the spring in area to the header support block. Affix the rail of the operator to the bracket and mount the electric motor. To mount the trim, make use of a paint scrape to obtain rid of the old caulk. The vinyl trim is installed with coating nails. Painting the door.
Step the elevation as well as width of the panel, as well as note the facility of each panel with a pencil or marker. Apply double-stick adhesive at the mark, as well as attach the retainer clip. Repeat this procedure for each and every panel. Connect 2 retainer clips for big panels.
Make use of the makers' directions to remove the old door. It primarily includes carefully unlatching the door from the wheel system, after that taking apart the panels of the door and loosening the tracks. See to it to get rid of one panel each time, or they can all fall in on you.
As soon as satisfied that the rollers won't bind in the track, secure it with screws. Attach the horizontal track and vertical track. It is very important that both straighten correctly or the door will certainly be out of line and the wheel will certainly bump. Incorporate the horizontal track. Attach the tracks beyond. The end bearing is what the stress rod will slide through as well as spin. It is straightforward to set up. Both plates take place the exterior. A hex head goes in all-time low and also a carriage bolt in the top.