Attach hinges to the top of each panel. Several brand-new doors had pilot holes pierced by the manufacturer. Affix axle sustains to the base of the lower panel and also to the top of the top panel. Area the lower panel into the door opening. Hold the panel upright by driving a nail right into the wall surface alongside the panel as well as bending it over to hold the panel in position. See to it it's degree prior to attaching the following panel.
Rest the curved section of the track on the upright item, and also connect the other end to the ceiling bracket. Make use of the very same ceiling sustains that were used with the old door. Construct the pieces to support the springtime assembly, and also affix them to the track. Inspect the user's manual to earn certain you're setting up the assembly in the proper place.
Locate the facility of the opening, as well as mark it on the door header. You will certainly affix the assistance for the spring there later. Attach the spring anchors to the springs, after that attach the spring locking cone. The securing cone needs to be on firmly: it maintains the spring from standing out loose under high tension.
Thread the cable with the cable television winder and cover it around. When the cable is covered, tighten down the set screws. If chosen, a specialist can be employed to wind the springtime. Install the braces to hold the new operator. Make absolutely certain they are safely in position. A couple much more brackets suspend and support the real motor of the driver.
Set up the pieces to sustain the spring setting up, and affix them to the track. Check the user's manual making sure you're mounting the assembly in the appropriate place. Relax the curved portion of the track on the vertical item you set up previously, and also connect the other end to the ceiling brace.
Get rid of the nuts on top of the next panel down. The first panel needs to come right out. Proceed this procedure until all the panels have actually been gotten rid of. Remove the old door tracks and also the laser sensor that maintains the door from shutting when a things is beneath it. Remove the brackets holding the track in place. Separate the track from the brackets that enable it to hang from the ceiling. Keep a firm grip on the rail or it will fall.